Connector authorization
All Miradore connectors must be authorized before they can be run. Authorization is done in Miradore management console > System settings > Connectors. Connectors are identified by connector type and fully qualified domain name of the connector device.
|
|
Task |
|
|
Install connector and run it once. |
|
|
Navigate to "System settings > Connectors" in the management console of Miradore and open the connector item which you wish to authorize. |
|
|
On connector item page, set Status to active and do other configurations if needed. |
Notice! Authorization process works only with connectors released with Miradore 2.8.0 or newer versions.
Troubleshooting
Connector's status is active but connector's local log says that it's not authorized: Connector's local authorization key has been changed, connector may have been reinstalled or key have been modified manually. You have to remove connector from system settings and redo authorization.